I am thinking of macros that can change from RUN to S&P mode
>automaticly? or is there a better mode of Operation? Could a seasoned
>SPRINTER maybe list his/her Macros?

I'm hardly seasoned, but here are mine. They are a work in progress.

F1 CQ,{TX}{ENTER}{CLEARRIT}CQ NA * * CQ {RX}
F2 Exch,{TX}* # HANK # HANK CA {RX}
F3 TU,{TX}{ENTER}{CLEARRIT} RRR {S&P} {RX}
F4 {MYCALL},{TX}{ENTER}W6SX W6SX {RX}
F5 His Call,{TX}{ENTER} ! {RX}
F6 QSO B4,{TX}{ENTER} ! QSO B4 W6SX CQ {CLEARRIT}{WIPE}{RX}
F7 Call?,{TX}{ENTER} CALL? {RX}
F8 Agn,{TX}{ENTER}AGN AGN {RX}
F9 Nr?,{TX}{ENTER}! NR NR? {RX}
F10 S&&P,{S&P}
F11 Wipe,{WIPE}
F12 Log,{LOG}
F1 S&&P CQ,{TX}{CLEARRIT}{ENTER}CQ NA * * CQ {RX}
F2 S&&P Exch,{TX}{ENTER} ! # HANK # HANK CA * {CLEARRIT}{RUN}{RX}
F3 S&&P QSL,{TX} ! RRR {RX}
F4 W6SX,{TX}{ENTER}W6SX W6SX {RX}
F5 His Call,{TX}{ENTER}! {RX}
F6 Name?,{TX}{ENTER}NAME? {RX}
F7 Call?,{TX}{ENTER}CALL CALL? {RX}
F8 Agn,{TX}{ENTER}AGN AGN {RX}
F9 Nr?,{TX}{ENTER}! NR NR? {RX}
F10 Run,{RUN}
F11 Wipe,{WIPE}
F12 Log,{LOG}

Under N1MM, Windows select Check, Digital Interface, Entry Window,
Log, and Visible Dupesheet.

Under N1MM, Config check Enter sends message (ESM).

Under N1MM, Config, Configure Ports ..., Function Keys, uncheck Work
Dupes and Send leading zeros in serial numbers.



>And finally... I do have this understood right???
>
>1. I CQ...get a Call, Exchange Nrs and move 1KHz
>2. I Call, Exchange Nrs....then take over Frequ and then goto 1.

Yes.

There is a practice session tonight 0230-0300.

Good luck. Have fun. Work me on three bands.